Konica Minolta AccurioLabel 230, Quick Manual, Page: 101 / 194

AccurioLabel 230 4-33
4.5 Splicing the media (For cleaning/clearing paper jam) 4
4.5 Splicing the media (For cleaning/clearing paper jam)
When cleaning the inside of the main body or clearing a paper jam, remove the media from the main body.
In this case, it is necessary to cut or connect the media in other than the
workbench of Roll Winder RW-110 .
This section describes how to connect the media using Roll Winder RW-210 and the main body after clean-
ing or clearing a paper jam.
NOTICE
It is difficult to connect the edges of the media in other than the workbench, so connect the edges of the me-
dia by overlapping them.
4.5.1 Connect the media between Roll Winder RW-210 and the main body
To connect the media in other than the workbench, prepare the following items.
-
Scissors
-
Masking tape (more than 30 mm / 1.18" in width)
1
Overlap the end of the media remaining onto the end of the media that has been cut between the main
body and
Roll Winder RW-210 , by about 10 cm.
2
Adhere the joint of the media from the back side with masking tape.
%
Stick to protrude the masking tape from both ends of the media.