Konica Minolta AccurioLabel 230, Quick Manual, Page: 169 / 194

AccurioLabel 230 6-19
6.5 A media feeding error occurs 6
6.5.1 Media snakes or is mis-centered
If paper snakes or leans to one side, the edge of the media may be damaged or images may be out of align-
ment.
If a meandering or mis-centering occurs, possible causes are as follows:
-
The media of the rewinder spindle is wound being misaligned.
-
The media is not set in the right position.
-
The conveyor section is dirty with adhesive.
-
The media is not set in the right conveyance position.
Follow the procedures below to solve the problem:
STEP 1: Replace the Media Wound Being Misaligned

Remove the media wound being misaligned from the rewinder spindle to replace it.
%
For details, refer to page 4-29.
STEP 2: Check the Position of the Media

Check if the media is set in the right position.
%
For details, refer to page 5-10.
STEP 3: Clean the Adhesive Sticking on the Parts

Clean the leading section if it is dirty with adhesive.
%
For details, refer to page 5-5.
STEP 4: Adjust the Media Conveyance Position

Adjust the media conveyance position.
%
For details, refer to page 6-20.
STEP 5: Confirm the Air Pressure of the Manometer

If meandering and mis-centering are not solved even after STEP 4, check the air pressures of the
manometers of the feeding dancer arm, winding dancer arm, and nip.
%
For details, contact your service representative.