Kongsberg Simrad CP200-5C, Installation Manual

Page: 64 / 110

62
484164/A
• The thread locking feature if integrated in the internal thread
• Modified profile with ramp surface in the direction of stress
• 30° ramp surface provides self-locking effect
• Easy assembly
• No assembly errors (forgetting the locking device) possible
• Use the standard external threads (screws) with tolerance class "medium"
• Even distribution of stress over the whole tread length
• No stripping of threads
• Economically efficient locking system, no additional components are necessary
• Undiminished holding power even under dynamic stress
• Repeated loosening and re-tightening without loss of function
• Internal threads can be produced with Emuge taps, cold forming taps or thread milling
cutters
• Larger thread hole diameters, i.e. increased tool life for threading tools
• Larger tolerance for thread hole diameters
Drawing standard
Whenever self-locking threads are required, this
is shown on the technical drawing. In the case of
tapping through holes, the arrow at the end of the
center line illustrates the screw-in direction of the
bolt.
The drawing is normally provided with the following
- or similar - text:
Drill diameters for threads differ
from standard. Self-lock taps can be supplied by
Kongsberg Maritime.
Note
Refer to manufacturer’s website for the latest
drawings and information about the self-locking
taps. The illustrations and information provided here is for reference only.
Taps
The pretension locking thread self-lock (taps) from manufacturer Emuge must be used.
Simrad CP200-5C Installation Manual