Kongsberg Simrad CP200-5C, Installation Manual, Page: 83 / 110

484164/A
81
12-pin Amphenol plug
The transducer socket on the transceiver allows you to connect one or more single or split
beam transducers using a 12-pin Amphenol plug (97-24-19P).
In order to connect the transducer cable to the plug, the plug must be disassembled as
described below.
A
Disassemble the plug.
B
Remove a few
millimeters of the
insulation on the
individual cables.
C
Fold the outer and inner
screen backwards, and
fasten them temporary
with tape.
D
Thread each
wire through a
heat-shrinkable tubing,
solder the wire end
to the appropriate pin,
and insulate with the
heat-shrinkable tubing.
E
Remove the tape from
the outer and inner
screen, and spread the
screens out to place
them between the large
washers.
F
Assemble the plug
house, and tighten the
rubber sleeve.
Related topics
Cable layout and
interconnections, page 77
Cable layout and interconnections