Komatsu Utility 97SF11205, Operation & Maintenance Manual

Page: 93 / 296

91
INSTRUMENTS AND CONTROLS
STARTING THE ENGINE
SAFETY CODE PUSH BUTTON (9)
•
Shift the lever to the neutral position (N), turn the ignition key to
position «I» and make sure that the display indicates (88). Start
the engine. After a quick self-test phase, the 2
nd
gear with semi-
automatic logic (SA) will be shown on the display (15).
IMPORTANT
☞
•
If the engine is not started within 20 seconds (program-
mable) after turning the ignition key to position «I», the
electronic system inhibits the control and displays the fig-
ure code dP on the display (15); turn the key to position
« » and repeat the starting procedure.
•
If the lever is not in the neutral position, the red led N (4)
comes on and the engine does not start.
•
If the anti-theft function has been connected before stop-
ping the engine, after the self-test it is necessary to enter
the anti-theft code.
+
-
FWD
REV
N
RWA12440
4 15
•
The anti-theft function is connected by pressing the push but-
ton (9) (led 10 on) for at least 3 seconds before stopping the
engine (this operation must be carried out by those who know
the secret code). If the push button (9) is pressed more than
once, the function is connected and disconnected in se-
quence, with the led (10) coming on and going out alternately.
IMPORTANT
☞
•
After the engine start and the self-test phase, if the anti-
theft function has been previously connected (led 10 on),
the secret code must be entered by keying the figures in
one by one with the UP/DOWN buttons, while the push
button 12 (DIM) must be used to confirm the entries.
•
After the entry of the correct safety code and the succes-
sive acoustic confirmation, the anti-theft function is auto-
matically excluded (led 10 off); to connect this function
again, press the push button (9) before stopping the en-
gine.
•
The anti-theft code is made up of 4 digits and is connected
with the S/N stamped on the casing. The digits are selected by
means of the UP/DOWN buttons (09) and each digit is con-
firmed with the button 12 (DIM). After the 4
th
digit has been
confirmed, the electronic system acquires the code with 3
short beeps (0.3 secs) and the 2
nd
gear with semiautomatic
logic SA is displayed.
IMPORTANT
☞
•
If an INCORRECT digit is confirmed, (88) appears on the
display and a long beep (1 sec) is emitted; repeat the op-
eration entering the right code.
•
After five consecutive incorrect confirmations, stop the
engine and start it again.
RWA12450
+
-
9 12
10