AKD Installation | 9 Electrical Installation
9.21.4 SynqNet
You can connect to the SynqNet Network via RJ-45 connectors X5 (in port) and X6 (out
port).The communication status is indicated by the built-in LEDs.
Connector
LED#
Name
Function
X5
LED1
LINK_IN
ON = receive valid (IN port)
OFF= not valid, power off, or reset.
LED2
CYCLIC
ON = network cyclic
BLINK = network not cyclic
OFF = power off, or reset
X6
LED3
LINK_OUT
ON = receive valid (OUT port)
OFF = not valid, power off, or reset
LED4
REPEATER
ON = repeater on, network cyclic
BLINK = repeater on, network not cyclic
OFF = repeater off, power off, or reset
9.21.5 PROFINET
AKD with connectivity option
PN
can be connected to a PROFINET network via RJ-45 con-
nector X11. PROFINET RT protocol is used. The communication status is indicated by the
built-in LEDs.
Connector
LED#
Name
Function
X11
LED1
IN port Link
ON = active, OFF= not active
LED2
RUN
ON = running, OFF = not running
Connect the service interface (X11) of the drive to an Ethernet interface on the PROFINET
Master directly or via a network switch,
while the supply to the equipment is switched
off.
Use standard Cat. 5 Ethernet cables for connection.
Confirm that the link LED on the AKD (the green LED on the RJ45 connector) and on your
Master or Switch are both illuminated. If both lights are illuminated, then you have a good elec-
trical connection.
The subnet mask of the AKD is 255.255.255.0. The first three octets of the drive’s IP address
must be the same as the first three octets of the HMI’s IP address. The last octet must be dif-
ferent.
PROFINET RT and WorkBench can operate simultaneously if a switch is used.
9.21.6 Ethernet/IP
AKD with connectivity option
EI
can be connected to an Ethernet/IP network via RJ-45 con-
nector X11. The communication status is indicated by the built-in LEDs.
Connector
LED#
Name
Function
X11
LED1
IN port Link
ON = active, OFF= not active
LED2
RUN
ON = running, OFF = not running
Connect the service interface (X11) of the drive to an Ethernet interface on the Ethernet/IP
Master directly or via a network switch,
while the supply to the equipment is switched
off.
Use standard Cat. 5 Ethernet cables for connection.
Confirm that the link LED on the AKD (the green LED on the RJ45 connector) and on your
Master or Switch are both illuminated. If both lights are illuminated, then you have a good elec-
trical connection.
The subnet mask of the AKD is 255.255.255.0. The first three octets of the drive’s IP address
must be the same as the first three octets of the HMI’s IP address. The last octet must be dif-
ferent.
Ethernet/IP and WorkBench can operate simultaneously if a switch is used.
182
Kollmorgen | kdn.kollmorgen.com | October 2017
