Kodak RP X-OMAT M6B, Service Manual, Page: 73 / 161

Component Checkout Procedure
Springs
(1) Check the SPRINGS for cleanliness and wear. Install new SPRINGS
if necessary.
(2) Check that the SPRINGS are correctly positioned.
(3) Check that the SPRINGS are adjusted for the correct tension.
Rewet Rollers (1) Check that the REWET ROLLER touches the ROLLERS above and
below it.
Turnaround Assemblies
Rollers (1) Check that the ROLLERS are clean and smooth.
Springs (1) Check the SPRINGS for cleanliness and wear. Install new SPRINGS
if necessary.
(2) Check that the SPRINGS are correctly positioned.
(3) Check that the SPRINGS are adjusted for the correct tension.
Main Drive Assembly
Drive Chain (1) Check the CHAIN for wear. Install a new CHAIN if necessary.
(2) Check that the CHAIN is adjusted for the correct tension.
(3) Lubricate the CHAIN as necessary. See the Lubrication Table on
page 3-9.
Bearings and Sprockets (1) Check the BEARINGS AND SPROCKETS for wear. Install new
BEARINGS and SPROCKETS if necessary.
(2) Check whether the TEETH of the SPROCKETS have become too
sharp due to wear. If the TEETH are too sharp, install new
SPROCKETS.
(3) Remove all burrs from the WORM GEARS.
Plumbing Connections (1) Check all connections for leaks.
Recirculation System
NOTE
In addition to checking the system during the periodic maintenance
procedures, check the system when you change solution.
Developer and Fixer (1) Check the RECIRCULATION SYSTEM by operating the PUMPS. If
Recirculation you see movement on the surface of the solution, the
RECIRCULATION SYSTEM is operating.
Developer Temperature (1) Check that the DEVELOPER temperature is within the specified range
by inserting a THERMOMETER of known accuracy into the
DEVELOPER TANK.
246628 3-7