Kodak RP X-OMAT M6B, Service Manual, Page: 71 / 161

SECTION 3
Preventive Maintenance Checklist
Component Checkout Procedure
.
Film Guide Assembly
(1) Check the bottom of the FILM GUIDE ASSEMBLY for corrosion and
dirt. Remove all corrosion or dirt found.
(2) Check the top of the FEED STAND for corrosion and dirt. Remove all
corrosion or dirt found.
(3) Check that the FILM GUIDE ASSEMBLY is correctly aligned with the
DETECTOR CROSSOVER ROLLERS.
Detector Crossover and
Crossover Assemblies
When you remove the CROSSOVER ASSEMBLIES from the processor, set
the top side on a flat, smooth surface. This prevents twisting them out of
square or changing the setting of the GUIDE SHOE.
Rollers (1) Check that the ROLLERS are clean and smooth.
Gears (1) Check that the GEARS of the ROLLERS for broken TEETH. Install
new ROLLERS if necessary.
(2) Check the DRIVE GEAR for wear or burrs. Install new GEARS if
necessary.
(3) Check the DETECTOR CROSSOVER ASSEMBLY for the correct
alignment by doing the following steps.
a. Remove the DETECTOR CROSSOVER ASSEMBLY from the
processor.
b. Place the top side of the DETECTOR CROSSOVER ASSEMBLY
on a flat, smooth surface.
c. Check that the SIDE PLATES are square against the flat, smooth
surface.
d. Check that the DETECTOR CROSSOVER ASSEMBLY seats
correctly when you install it.
Guide Shoes (1) Check that the LONGER TIPS are in the direction of the film travel.
Bearing, Brackets, and Nuts (1) Check the BEARINGS, BRACKETS, and NUTS for wear and broken
parts. Install new parts if necessary.
246628 3-5