Kodak RP X-OMAT M6B, Service Manual, Page: 20 / 161

Rack Assemblies
Adjusting the Tension of the Chain
[1] Check the CHAIN tension after the RACK has
been immersed in solution.
[2] Check that the RACK is at relatively the same
temperature as the solutions in the tanks.
[3] Loosen the 4 HOLDING SCREWS.
[4] Hold the RACK assembly above the work
surface. (This will allow the TURNAROUND
to move by gravity to the correct CHAIN
tension.)
[5] Rotate the DRIVE GEAR one full turn.
Tighten the 2 HOLDING SCREWS on the
drive side first.
[6] Set the RACK down on the work surface.
[7] Use the ADJUSTING SCREWS. Make the
distance between the RACKS SIDE PLATE
and the TURNAROUND SIDE PLATE on the
non-drive Side equal to that of the drive side.
[8] Tighten the 2 HOLDING SCREWS on the
non-drive Side.
NOTE
Remove LINKS of the CHAIN as
necessary to provide the correct
length.
Installing a Chain
[1] To open the CHAIN, insert a SCREWDRIVER
under each open end of the LINK.
[2] Turn the SCREWDRIVER.
H048_0125CA
CROSSBAR
LINK
ADJUSTING
SCREW (4)
HOLDING
SCREW (4)
TURNAROUND
ASSEMBLY
Direction of Travel
H048_0125CCC
[3] Install the CROSSBAR of each LINK in the
Figure 11 Adjusting the Tension of the Chain
direction of travel, with the LINKS opening
outward. See Figure 11.
[4] Attach the new CHAIN to the existing CHAIN.
[5] Pull the existing CHAIN through the RACK
until the new CHAIN is in the correct position.
[6] Disconnect the existing CHAIN from the new
CHAIN.
[7] Fasten the ends of the new CHAIN together.
[8] Do the Chain Adjustment above.
2-8 246628