Kodak RP X-OMAT M6B, Service Manual, Page: 52 / 161

Developer Temperature Control System
Dangerous voltage.
Removing and Replacing the Developer Heater
[1] Disconnect the main power.
[2] Drain the DEVELOPER TANK or use PINCH CLAMPS on the 2 TUBES to the THERMOWELL.
[3] Disconnect the CONNECTOR P12 at the ELECTRICAL BOX.
A small amount of liquid may spill.
[4] Remove the DEVELOPER HEATER from the THERMOWELL.
60
5 mm
(13/64 in.)
13.9 cm
(5.500 .060 in.)
H048_0153BA
H048_0153BCA
HEATER LOCATOR
THERMOWELL
LOCATOR
HEATER
HEATER
DEVELOPER
Figure 44 Removing the Developer Heater from the Thermowell
[5] Check that the HEATER LOCATOR is in the correct location.
Over-tightening may cause damage to the THERMOWELL.
[6] To install the new HEATER, use SILASTIC SEALANT RTV 102, or equivalent on the THREADS. Hand
tighten, plus one-half turn.
2-40 246628