Kodak RP X-OMAT M6B, Service Manual, Page: 17 / 161

Crossover Assemblies
Adjusting the Side Plates for Squareness
[1] Remove the DETECTOR CROSSOVER
ASSEMBLY from the processor.
[2] Set the DETECTOR CROSSOVER
ASSEMBLY on a flat surface as shown.
[3] Loosen the SCREWS and the NUTS of the
TIE RODS.
[4] Check the SIDE PLATES for squareness
against the flat surface.
[5] Tighten the SCREWS and the NUTS.
NOTE
The GUIDE SHOES are not adjustable.
Check that the longer TIPS of the
GUIDE SHOES are in the direction of
the film travel.
[6] Repeat the procedure for the other
CROSSOVER ASSEMBLIES.
H048_0155CA
H048_0155CCB
GUIDE
SHOE
LONG
TIP
SHORT
TIP
Figure 6 Checking the Guide Shoes
H048_0157BA
CROSSOVER
ASSEMBLY
GUIDE
SHOE
H048_0157BCB
Figure 7 Adjusting the Side Plates of the Detector Crossover Assembly
246628 2-5