Kodak RP X-OMAT M6B, Service Manual, Page: 31 / 161

SECTION 3
Dryer
[5] Loosen the 2 SETSCREWS to remove the
Blower Assembly
PULLEY from the BLOWER ASSEMBLY.
[6] Install the PULLEY onto the new BLOWER
Removing the Blower Assembly
ASSEMBLY.
[1] Remove the BLOWER MOTOR COVER from
[7] Install the new BLOWER ASSEMBLY using
the BLOWER DRIVE MOTOR.
the 3 MOUNTING BOLTS from Step 2.
[2] Remove the 3 MOUNTING BOLTS from the
[8] Loosen the BLOWER DRIVE MOTOR
BLOWER ASSEMBLY.
MOUNTING BOLTS.
[3] Remove the BLOWER DRIVE BELT.
[9] Install the BLOWER DRIVE BELT.
[4] Remove the BLOWER ASSEMBLY.
[10] Adjust the position of the BLOWER DRIVE
MOTOR to obtain the correct tension and
alignment of the BLOWER DRIVE BELT. See
Figure 25.
[11] Install the BLOWER MOTOR COVER.
NOTE
Correct tension is achieved when the
BLOWER DRIVE BELT does not make
loud noises when you energize the
processor.
H048_0151AA
Figure 25 Adjusting for Correct Tension and
Alignment of the Blower Drive Belt
H108_0072CA
BLOWER
MOTOR
COVER
SCREW
WASHER
BLOWER
DRIVE BELT
PULLEY
BLOWER
DRIVE
BELT
BLOWER
ASSEMBLY
BLOWER
MOUNTING
BOLT (3)
BLOWER
DRIVE
MOTOR
H108_0072CCC
Figure 24 Removing the Blower Assembly
246628 2-19