Kodak RP X-OMAT M6B, Service Manual, Page: 57 / 161

SECTION 5
Electrical
Developer Temperature Control
Adjusting the Developer Temperature
[1] Remove the RECEIVING BIN ACCESS PANEL to gain access to the ELECTRICAL BOX.
Possible damage from electrostatic discharge. Use an ESD wrist strap.
See Figure 48 on page 2-47.
[2] Do the following to check for 9
±
0.1 V dc between TP5 and TP10:
• If necessary, adjust POTENTIOMETER R63 to obtain 9 V dc.
• Turn clockwise to increase the voltage, or counterclockwise to decrease the voltage.
Do the following adjustment by measuring the voltage between TP-7 and TP-10.
[3] Adjust DEV TEMP potentiometer R82 clockwise to increase, or counterclockwise to
decrease the voltage. Refer to the Table below for approximate values.
Table 5 Approximate Values for Pre-setting the Developer Temperature
Measure Voltage
Desired Temperature
between TP7 and
°
C
°
F TP10
34.0 93.2 3.10 V dc
34.5 94.1 3.06 V dc
35.0 95.0 3.03 V dc
35.5 95.9 3.00 V dc
36.0 96.8 2.96 V dc
[4] Install the RECEIVING BIN ACCESS PANEL.
[5] Energize the processor.
[6] Allow 20 - 30 minutes for the processor to stabilize at the set-point temperature. The DEVELOPER
INDICATOR will flash as the processor approaches operating temperature.
246628 2-45