Kodak RP X-OMAT M6B, Service Manual, Page: 62 / 161

Calibrating the Meter-To-Tank Temperature
Possible damage from electrostatic discharge. Use an ESD wrist strap.
[1] Check that the DEVELOPER TEMPERATURE METER zero adjustment is correct. See the previous
procedure.
[2] Turn the DRYER TEMPERATURE CONTROL KNOB fully counterclockwise .
[3] Allow 20 - 30 minutes for the processor to stabilize at the set-point temperature. reach its normal
operating temperature. The DEVELOPER INDICATOR will flash as the processor approaches operating
temperature.
IMPORTANT
All PANELS and COVERS must be installed on the processor and the developer temperature
allowed to stabilize between each adjustment.
[4] Using a THERMOMETER of known accuracy, measure the temperature of the DEVELOPER, 150 mm
(6 in.) below the surface.
[5] Move MTR SWITCH S2 to SET. See Figure 50 on page 2-49.
[6] Rotate MTR POTENTIOMETER R83 until the reading on the DEVELOPER TEMPERATURE METER
matches the reading on the THERMOMETER in the DEVELOPER TANK.
[7] Remove the THERMOMETER from the DEVELOPER TANK.
[8] Move MTR SWITCH S2 to the NORM position. See Figure 50 on page 2-49.
[9] Turn the DRYER TEMPERATURE CONTROL KNOB to the desired position.
Film Clear Time Circuit
Film Clear Time is the minimum operation time before the processor operates in STANDBY mode.
IMPORTANT
The FILM CLEAR TIME SWITCHES are factory set as follows:
• U20-3 is set to the right ‘‘ON’’ position.
• U20-4 is set to the left ‘‘OFF’’ position.
Do not change the position of these switches.
Possible discharge from electrostatic discharge. Use an ESD wrist strap.
2-50 246628