Kodak RP X-OMAT M6B, Service Manual, Page: 34 / 161

Blower Impeller Shaft
Removing and Replacing the Blower Impeller Shaft
Moving parts.
[1] Disconnect the main power.
[2] Loosen the BLOWER MOTOR and remove the BLOWER BELT.
[3] Loosen the 2 SETSCREWS on the BLOWER DRIVE BELT PULLEY.
[4] Remove the BLOWER DRIVE BELT PULLEY.
[5] Loosen the INNER BEARING SETSCREWS.
[6] Remove the OUTER BEARING COVER and loosen the OUTER BEARING SETSCREWS. See
Figure 27 on page 2-21.
[7] Remove the 7 SCREWS and 7 WASHERS and the HOUSING COVER.
[8] Remove the SHAFT and IMPELLER ASSEMBLY.
[9] Loosen the 2 IMPELLER SETSCREWS.
[10] Remove the IMPELLER from the SHAFT.
[11] Install the IMPELLER on the new SHAFT.
[12] Reverse the procedure to reassemble the BLOWER ASSEMBLY.
[13] Ensure that the SETSCREWS align with the FLATS on the SHAFT.
HOUSING
COVER IMPELLER
SETSCREW
IMPELLER
ASSEMBLY
BLOWER DRIVE
BELT PULLEY
SETSCREW
BLOWER
DRIVE
BELT
INNER
BEARING
IMPELLER
SHAFT
OUTER
BEARING
OUTER
BEARING
COVER
H108_0073BCB
Figure 28 Removing the Blower Impeller Shaft
2-22 246628