Kodak RP X-OMAT M6B, Service Manual, Page: 21 / 161

Resilient G Roller (Developer and Fixer Racks)
Removing and Replacing the G Roller
[1] Remove the SPRING from both ends on the top of the RACK. See Figures 12 and 13.
[2] Remove the SCREWS, WASHERS, GEAR, SPACERS, and BEARINGS from the outside of both SIDE
PLATES.
[3] Rotate the SHAFT so that the KEYWAY is in the up position. See Figure 13.
[4] Pull the ROLLER to the non-drive side and remove the KEY from the SPROCKET.
[5] Pull the SHAFT to the non-drive side to be free of the SIDE PLATE.
[6] Remove the THRUST WASHER, SPROCKET, and SPACER.
[7] Continue to pull the SHAFT to the non-drive side.
[8] Remove the ROLLER.
[9] Reverse the procedure to assemble.
H048_0045DA
SIDE
PLATE
RESILIENT
G ROLLER
SIDE
PLATE
SPRING
Drive Side
Non-Drive
Side
H048_0045DCB
Figure 12 Removing the Resilient G Roller from the Developer or Fixer Rack
246628 2-9