KitchenAid Pro Line KHWV01RSS, Technical Education

Page: 94 / 104

6-8
DIAGNOSTIC TEST
Refer to the Overview Test Program chart be-
low. The washer must be empty and the control
must be in the OFF state before pressing the
button sequence to start the test.
Starting the Test Mode
Close the door.
Under Cycles, press DRAIN/SPIN.
Press SPIN SPEED and select NO SPIN. •
•
•
Under Options, press PREWASH button
four times within 5 seconds. Three beeps
will sound.
If the Starting procedure fails, press PAUSE/
CANCEL, then repeat the starting procedure.
Test Program Control
In order to advance to the next step of the test
procedure, press PREWASH Option button
two times.
•
Indication Actuators To Be Checked Control Action
C:00
Drum rotates counterclockwise at maximum speed.
- If max. speed =EXTRA HIGH, drum speed =
>1000 rpm.
- If max. speed =HIGH, drum speed = >800
• Door lock system
• Flowmeter
• Cold water inlet valve
• Dispenser motor
• Dispenser contact
• Hot water inlet valve
• Motor
• Motor Control (MCU)
• Heater (if present on this model)
• NTC
• Drain pump
• Motor
• Motor Control (MCU)
• Motor
• Motor Control (MCU)
Door locks.
Fill by cold water inlet valve.
Distribution system is set to Prewash position.
Fill by hot water inlet valve.
Drum rotates clockwise at wash speed.
Heater (if present on this model) is switched ON.
Drum rotates clockwise at wash speed.
If there is not enough water in the tub, the water inlet
valve will be switched ON to achieve the minimum
water volume.
Drain pump is ON.
Drum rotates counterclockwise from 35 to 90 rpm
within 15 seconds.
C:01
C:02
C:03
C:04
C:05
C:06
C:07
C:08
OVERVIEW TEST PROGRAM