5-3
Refer to page 4-4 for the procedure for access-
ing the door lock/switch assembly.
1. Unplug washer or disconnect power.
2. Set the ohmmeter to the R X 1 scale.
3.
To test the door switch:
a) Disconnect the connector from the
CCU.
b) Touch the ohmmeter test leads to the
two connector pins. The meter should
indicate as follows:
Door closed = 0
Ω
.
Door open = infinite (open circuit).
DOOR LOCK/SWITCH ASSEMBLY
Door Switch Actuator
Pins1 - 3
Pins 4 - 7
Door Lock Switches
Pins 1 & 2
c) Reconnect the door lock/unlock sole-
noid connector to the CCU.
5.
To test the door lock main switches:
a) Turn the washer on and select a cy-
cle.
b) Press START and you should hear the
door lock solenoids engage.
c) Unplug the washer from the wall out-
let.
d) Disconnect the door lock main switch
connector from the CCU.
e) Touch the ohmmeter test leads to the
indicated connector pins. The meter
should indicate as follows:
Main switch 1 at pins 4 and 5 = 0
Ω
.
Main switch 2 at pins 6 and 7 = 0
Ω
.
45 67
2 1
1 2 3
4.
To test the door lock/unlock sole-
noids:
a) Disconnect the connector from the
CCU.
b) Touch the ohmmeter test leads to the
indicated connector pins. The meter
should indicate as follows:
Lock solenoid at pins 1 and 3 = 60 Ω.
Unlock solenoid at pins 2 and 3 = 60 Ω.
c) Reconnect the door switch connector
to the CCU.
(Connector Viewed From Wire End)
(Connector Viewed From Wire End)
(Connector Viewed From Wire End)
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Summary of Contents for Pro Line KHWV01RSS
