KitchenAid Pro Line KHWV01RSS, Technical Education

Page: 15 / 104

2-7
2. Attach the blue water inlet hose to the
washer’s cold (C) water faucet. Screw on
coupling by hand until it is seated on the
washer.
3. Using pliers, tighten the couplings with an
additional two-thirds turn.
NOTE: Do not overtighten. Damage to the
coupling can result.
4. Turn on the water faucets completely and
check for leaks.
NOTE: Replace original inlet hoses after 10 years
of use to reduce the risk of hose failure. Record
hose installation or replacement dates on the
hoses for future reference.
Periodically inspect and replace hoses if bulges,
kinks, cuts, wear, or leaks are found.
SECURE THE DRAIN HOSE
1. Drape the power cord over the washer
top.
2. Secure the drain hose to the laundry tub
leg or standpipe with the cable tie provided.
See illustrations A and B.
A B C
If the washer faucets and the drain stand-
pipe are recessed (see illustration C), put
the hooked end of the drain hose in the
standpipe. Tightly wrap the cable tie around
the water inlet hoses and the drain hose.
NOTES:
Do not force excess drain hose back into the
rear of the washer.
Do not force excess drain hose into the
standpipe.
To avoid siphoning, do not seal the drain hose
into the standpipe. •
•
•
ATTACH DECORATIVE MAT
1. Locate the 2 holes in the back of your
washer.
Back view of washer
2. Place the flat washer and then the spacer
on the mounting screw and attach to the
washer using a Phillips screwdriver.
3. Check that the top of the washer and the
bottom of the mat are clean.
4. Set the mat in place on top of the washer.
Hook the back edge of the decorative mat
over the mounting screws.