KitchenAid Pro Line KHWV01RSS, Technical Education

Page: 9 / 104

2-1
INSTALLATION INFORMATION
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before start-
ing installation. Read and follow the instructions
provided with any tools listed here.
Tools needed for connecting the water inlet
hoses
Pliers that open to 1-9/16
˝
(39.5 mm)
Flashlight (optional)
Tools needed for installation
Adjustable or open end wrenchs 13 mm
and 9/16
˝
(14 mm)
Phillips screwdriver • Level
Wood block • Tape measure
Parts supplied
Remove parts package from the washer drum.
Check that all parts are included. Remove the
optional decorative mat (included) from the top
of the washer and set aside.
•
•
•
•
•
Alternate parts
If You Have You Will Need to Buy
Laundry tub or
standpipe taller
than 96" (2.4 m)
Sump pump system (if not already
available)
Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain Siphon break, Part Number 285834 ;
additional drain hose Part
Number 8318155 ; and connector kit,
Part Number 285835
Drain hose too
short
4 ft drain hose extension kit, Part
Number 285863
Water faucets
beyond reach of
fill hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314 ,
10 ft (3.0 m) Part Number 350008
A. Door handle
B. Door handle washers (2)
C. Door handle screws (2)
D. Transport bolt hole plug (4)
E. Cable tie
F. Inlet hose (2)
G. Drain hose form
H. Decorative mat mounting
screws (2)
I. Decorative mat flat washers (2)
J. Decorative mat spacers (2)
K. Decorative mat
K
H
J
I
A
B
E
G
F
D
C
OPTIONS
A pedestal may be purchased separately for
this washer. This pedestal will add about 11
˝
(27.9 cm) to the height of the unit for a total verti-
cal height of approximately 53
˝
(134.6 cm).
Optional Pedestal
To order, call the dealer from whom you pur-
chased your washer or refer to the “Assistance
or Service” section of the “Use & Care Guide.”
Ask for Model Number LAV2701RSS.