21
EN
2. Product description
2.3 - Technical features of the
control unit
Mains power supply
230 Vac ±10%, 50 - 60 Hz
Motor power supply
24V DC 280W e 10A
massimo picco per motore
Warning light power supply
24V max 15W
Gate pilot lamp power supply
24Vdc max 10 W
Accessories’ power supply
(photocells...)
24 Vdc max 10 W
Radio receiver frequency
433.920 MHz
Storable remote controls
170
Radio antenna input
RG58
Operating temperature
-20 ÷ 50 °C
2.1 - Commissioning
To start-up the system, the following steps must be carried out:
1 - Check cabling, tighten all connections and terminals. Follow
cabling standards and regulations of the country/region.
2 - Set the dip switches (par. 4.1) and knobs (par. 4.2) according
to the desired typs pf operation and the system structural
configuration.
3 - Memorise the transmitters (Paragraph 5).
4 - Programme the gate travel path (Paragraph 6) so that the
control unit learns the gates open and close points.
5 - Perform the checks described in the “Testing and
commissioning” paragraph (Paragraph 7).
m
If, after completing these steps, the control
unit should malfunction, consult Paragraph 8, “LEDs
indication”, to identify any issues, and Paragraph 10,
“F.A.Q”, to attempt to solve it.
2.2 - Main features
- Automated access command for 1 or 2 24V motors.
Configuration of dip switch one and two specify the
type of motor in use
- Flasher control with/without integrated intermittency function
(Paragraph 10.3).
- Integrated management for electric locks 24V max. 15VA
(Paragraph 10.4). This output can also be used to control
courtesy lights (Paragraph 14).
- Double NC input for opening and closing limit switch
(Paragraph 10.8).
- Inputs for start, stop and pedestrian opening wired
commands, customisable to open, stop and close (Paragraph
10.9).
- Double input for photocells and safety edges: PHO1 during
closing and PHO2 during closing and/or opening (Paragraph
10.5).
- Possibility of powering 24VDC accessories (Paragraph 10.6).
- Input for gate status pilot light signalling the position of the
leaves (Paragraph 10.7).
- Input for external antenna that can be used for increasing the
range of the transmitters (Paragraph 10.10).
- Staggered closing of gate leaves adjustable through the knob
(Paragraph 4.2).
- Pause time for automatic re-closing adjustable to between 0
and 180 sec. with knob (Paragraph 4.2).
- Obstacle sensitivity adjustment with knob (Paragraph 4.2).
- Motor force adjustment with knob (Paragraph 4.2).
- Incorporated radio receiver (433.92MHz), compatible with
King Gates rolling transmitters.
- 6 indication LEDs (Paragraph 8).
- Slow-speed opening and closing (customisable through
dedicated programming).
Summary of Contents for STARG8 24NG
Page 111: ......
