King gates STARG8 24NG, Installation And Use Instructions Manual

Page: 28 / 112

26
EN
5. Transmitter (remote
control unit) programming
m
The transmitters to be programmed must be of the
“Stylo4K”, “Stylo2K”, DigyPad, Myo C4, NovoTX, NovoDigy
series by King Gates. See adjacent pictures.
m
If, at the start of the following procedures, SET
RADIO and START LEDs are flashing, it means that the
programming protections have been activated – see
Paragraph 17.1. Therefore radio transmitters learning is not
possible.
m
To interrupt any of the following procedures at any
time, press the SET and RADIO buttons simultaneously or
wait 20 seconds.
5.1 - Start button programming
This procedure allows to programme a button of the transmitter
(remote control ) to the controll unit.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: the RADIO
led turns steady on (if not, see paragraph 17.1)
2. PRESS THE DESIRED BUTTON ON EVERY TRANSMITTER
TO BE PROGRAMMED: the RADIO led flashes
3. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS
OFF OR WAIT 20 SECONDS TO EXIT THE PROCEDURE
5.2 - Pedestrian opening button
programming
This procedure allows to programme a button of the transmitter
for partial / pedestrian opening to the control unit.
This opening width can be customised following the procedure
described in Paragraph 6. 2.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: the RADIO
led turns steady ON (if not, see paragraph 17.1)
2. PRESS THE START BUTTON FOR 1 SECOND: the RADIO
led flashes and the START led turns ON
3. PRESS THE DESIRED BUTTON OF ALL THE
TRANSMITTERS TO BE PROGRAMMED: the RADIO led
flashes
4. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS
OFF OR WAIT 20 SECONDS TO EXIT THE PROCEDURE
5.3 - Deleting all memorised
transmitters
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND
RELEASE WHEN RADIO LED FLASHES: the RADIO led
flashes (if not, consult Paragraph 17.1)
2. PRESS THE RADIO BUTTON AGAIN FOR 1 SECOND: the
RADIO led flashes fast
3. MEMORY DELETION COMPLETED: the RADIO led turns
OFF
5.4 - Deleting a single transmitter
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND
RELEASE WHEN RADIO LED FLASHES: the RADIO led
flashes (if not, consult Paragraph 17.1)
2. PRESS THE SET BUTTON FOR 1 SECOND: the RADIO led
flashes and the SET led turns ON
3. PRESS A BUTTON ON THE TRANSMITTER YOU WISH TO
DELETE: the RADIO led flashes and the SET led flashes
4. PRESS THE RADIO BUTTON UNTIL RADIO LED TURNS
OFF OR WAIT 20 SECONDS TO EXIT THE PROCEDURE
5.5 - Transmitter ( Remote ) tools -
free programming
This procedure enables you to program a new transmitter without
accessing the control unit, by staying close to it.
To run the procedure you will require a previously programmed
transmitter and you need to be at the gate.
1. ON A PREVIOUSLY PROGRAMMED
TRANSMITTER, HOLD DOWN
BUTTONS 1 AND 2 TOGETHER FOR 4
SECONDS
2. ON THE TRANSMITTER YOU WANT
TO PROGRAM, HOLD DOWN
BUTTONS 1 AND 2 TOGETHER FOR 4
SECONDS
1
2
1
2