Kilsen KFP-CX3E Series, Installation Manual

Page: 95 / 112

Appendix A: Configuration presets
KFP-CX3E Series Installation Manual 89
Basic configuration modes
EN 54-2 supervision and Class B fire outputs
Note: The following presets are available for installations that do not use
EN 54-13 supervision (the SU setting is Of). See “Supervision mode” on page 33
for more information.
Basic standard mode
Fire sounders cannot be manually activated in this operating mode (fire sounders
are only activated if there is a fire alarm).
The configured actuator delay is applied when the MCP Start is activated.
Table 36: Presets and zone characteristics
Preset Zone description Zone detection
01 Passive EOL Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
02 Passive EOL, CleanMe
enabled Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
Basic evacuation mode
Fire sounders can be manually activated at the operator user level in this
operating mode (a fire alarm is not required).
The actuator is activated immediately when the MCP Start is activated.
Table 37: Presets and zone characteristics
Preset Zone description Zone detection
05 Passive EOL Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
06 Passive EOL, CleanMe
enabled Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
BS 7273 mode stage 1
Fire sounders cannot be manually activated. Fire sounders are off during the
sounders delay.
Table 38: Presets and zone characteristics
Preset Zone description Zone detection
11 Active EOL Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
12 Active EOL, CleanMe
enabled Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection