Kilsen KFP-CX3E Series, Installation Manual

Page: 96 / 112

Appendix A: Configuration presets
90 KFP-CX3E Series Installation Manual
BS 7273 mode stage 2
Fire sounders cannot be manually activated. Fire sounders activated
intermittently during the sounders delay.
Table 39: Presets and zone characteristics
Preset Zone description Zone detection
13 Active EOL Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
14 Active EOL, CleanMe
enabled Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection
Repeater with fire routing (EN 54-2)
All input/output supervision is disabled. No fire and extinguishing functionality.
Table 40: Presets and zone characteristics
Preset Zone description Zone detection
61 Not used Not used
Repeater with fire routing (BS 7273)
All input/output supervision is disabled. No fire and extinguishing functionality.
Table 41: Presets and zone characteristics
Preset Zone description Zone detection
63 Not used Not used
EN 54-13 supervision and Class A expansion board
outputs
Note: The following presets are available for installations that use
EN 54-13 supervision (the SU setting is A). See “Supervision mode” on page 33
for more information.
Basic standard mode
Fire sounders cannot be manually activated in this operating mode (fire sounders
are only activated if there is a fire alarm).
The configured actuator delay is applied when the MCP Start is activated.
Table 42: Presets and zone characteristics
Preset Zone description Zone detection
01 EN 54-13 EOL Z1 and Z2 automatic, for extinguishing event
Z3 mixed, for fire detection