Keysight 33210A, User Manual

Page: 223 / 351

221
Chapter 4 Remote Interface Reference
Triggering Commands
4
OUTPut:TRIGger:SLOPe { POSitive | NEGative }
OUTPut:TRIGger:SLOPe?
Select a rising or falling edge for the “trigger out” signal. When enabled
using the
OUTP:TRIG
command (see below), a TTL-compatible square
waveform with the specified edge is output from the rear-panel Trig Out
connector at the beginning of the sweep or burst. Select “POS” to output a
pulse with a rising edge or select “NEG” to output a pulse with a falling
edge. The default is POS. The
:SLOP?
query returns “POS” or “NEG”.
• When the Immediate (internal) trigger source is selected
(
TRIG:SOUR IMM
command), the function generator outputs a square
waveform with a 50% duty cycle from the Trig Out connector. The
period of the waveform is equal to the specified sweep time (
SWE:TIME
command) or burst period (
BURS:INT:PER
command)
plus
1 ms.
• When the External trigger source is selected (
TRIG:SOUR EXT
command), the function generator automatically disables the
“trigger out” signal. The rear-panel Trig Out connector cannot be
used for both operations at the same time (an externally-triggered
waveform uses the same connector to trigger the sweep or burst).
• When the Bus (software) trigger source is selected (
TRIG:SOUR BUS
command), the function generator outputs a pulse (>1 µs pulse width)
from the Trig Out connector at the beginning of each sweep or burst.
OUTPut:TRIGger { OFF | ON }
OUTPut:TRIGger?
Disable or enable the “trigger out” signal (used for sweep and burst only).
When enabled, a TTL-compatible square waveform with the specified
edge (
OUTP:TRIG:SLOP
command) is output from the rear-panel
Trig Out connector at the beginning of the sweep or burst. The default
is OFF. The
:TRIG?
query returns “0” (OFF) or “1” (ON).
33210A users guide.book Page 221 Wednesday, July 16, 2008 11:16 AM