Keysight 33210A, User Manual

Page: 262 / 351

260
Chapter 4 Remote Interface Reference
Status Reporting Commands
4
See the table on page 255 for the register bit definitions.
STATus:QUEStionable:CONDition?
Query the condition register in this group. This is a read-only register
and bits are not cleared when you read the register. A query of this
register returns a decimal value which corresponds to the binary-
weighted sum of all bits set in the register.
STATus:QUEStionable [ :EVENt ] ?
Query the event register in this register group. This is a read-only register.
Once a bit is set, it remains set until cleared by this command or
*CLS
(clear status) command. A query of this register returns a decimal value
which corresponds to the binary-weighted sum of all bits set in the register.
STATus:QUEStionable:ENABle <
enable value
>
STATus:QUEStionable:ENABle?
Enable bits in the enable register in this register group. The selected bits
are then reported to the Status Byte. A
*CLS
(clear status) will not clear
the enable register but it does clear all bits in the event register.
The
STATus:PRESet
command clears all bits in the enable register.
To enable bits in the enable register, you must write a decimal value
which corresponds to the binary-weighted sum of the bits you wish to
enable in the register.
The
:ENAB?
query returns a decimal value which corresponds to the
binary-weighted sum of all bits enabled by the
STAT:QUES:ENAB
command.
Questionable Data Register Commands
33210A users guide.book Page 260 Wednesday, July 16, 2008 11:16 AM