Keysight 33210A, User Manual

Page: 212 / 351

210
Chapter 4 Remote Interface Reference
Frequency Sweep Commands
4
MARKer:FREQuency {<
frequency
>| MINimum | MAXimum }
MARKer:FREQuency? [ MINimum | MAXimum ]
Set the marker frequency. This is the frequency at which the signal
on the front-panel Sync connector goes to a logic low during the sweep.
The Sync signal always goes from low to high at the beginning of the
sweep. Select from 1 mHz to 10 MHz (limited to 100 kHz for a ramp
waveform). The default is 500 Hz. MIN = the start or stop frequency
(whichever is lower). MAX = the start frequency or stop frequency
(whichever is higher). The
:FREQ?
query returns the marker frequency
in hertz.
• When sweep is enabled, the marker frequency must be between the
specified start frequency and stop frequency. If you attempt to set the
marker frequency to a frequency not in this range, the function
generator will automatically set the marker frequency equal to the
start frequency or stop frequency (whichever is closer). From the
remote interface, a “Settings conflict” error will be generated and
the marker frequency will be adjusted as described.
MARKer { OFF | ON }
MARKer?
Disable or enable the frequency marker. When the frequency marker
is disabled, the signal output from the Sync connector is the normal
Sync signal for the carrier waveform (see “Sync Output Signal” on
page 66). The default is OFF. The
MARK?
query returns “0” (OFF) or
“1” (ON).
• The
OUTP:SYNC
command is overridden by the setting of the
MARK
command. Therefore, when the marker frequency is enabled (and the
sweep mode is also enabled), the
OUTP:SYNC
command is ignored
33210A users guide.book Page 210 Wednesday, July 16, 2008 11:16 AM