Keysight 33210A, User Manual

Page: 279 / 351

277
Chapter 5 Error Messages
Execution Errors
4
5
-221 Settings conflict;
triggered burst not available for noise
You cannot use the noise function in the triggered burst mode.
-221 Settings conflict;
amplitude units changed to Vpp due to high-Z load
The output units (
VOLT:UNIT
command) cannot be set to dBm if the
output termination is currently set to “high impedance” (
OUTP:LOAD
command). The function generator has converted the units to Vpp.
-221 Settings conflict;
trigger output connector disabled by trigger external
When the external trigger source is selected (
TRIG:SOUR EXT
command), the function generator automatically disables the
“trigger out” signal. The rear-panel Trig connector cannot be used for
both operations at the same time.
-221 Settings conflict;
trigger output connector used by burst gate
If you have selected the gated burst mode (
BURS:MODE GAT
command)
with burst enabled, the “trigger out” signal cannot be enabled
(
OUTP:TRIG ON
command). The rear-panel Trig connector cannot be
used for both operations at the same time.
-221 Settings conflict;
trigger output connector used by trigger external
When the external trigger source is selected (
TRIG:SOUR EXT
command),
the function generator automatically disables the “trigger out” signal.
The rear-panel Trig connector cannot be used for both operations at the
same time.
-221 Settings conflict;
frequency reduced for user function
For arbitrary waveforms, the output frequency is limited to 3 MHz.
When you change to the arbitrary waveform function (
APPL:USER
or
FUNC:USER
command) from a function that allows a higher frequency,
the function generator will automatically adjust the frequency to 3 MHz.
33210A users guide.book Page 277 Wednesday, July 16, 2008 11:16 AM