24
Chapter 2 Quick Start
To Set a DC Offset Voltage
2
To Set a DC Offset Voltage
At power-on, the function generator outputs a sine wave with a dc offset
of 0 volts (into a 50
Ω
termination). The following steps show you how to
change the offset to –1.5 mVdc.
1 Press the
“
Offset
”
softkey.
The displayed offset voltage is either the power-on value or the offset
previously selected. When you change functions, the same offset is used
if the present value is valid for the new function.
2 Enter the magnitude of the desired offset.
Using the numeric keypad, enter the value “–1.5”.
3 Select the desired units.
Press the softkey that corresponds to the desired units. When you select
the units, the function generator outputs the waveform with the displayed
offset (if the output is enabled). For this example, press
mV
DC
.
Note:
You can also enter the desired value using the knob and cursor
keys.
Summary of Contents for 33210A
