Keysight Technologies 16197A, Operation And Service Manual

Page: 13 / 73

Keysight16197A Operation and Service Manual 13
Installation Guide
Connecting the Test Fixture with a Measuring Instrument
Connecting the Test Fixture with a Measuring Instrument
Connecting the test fixture 16197A with a measuring instrument requires an
adapter suited to the instrument.
The test fixture 16197A is suitable for use with a high-frequency LCR meter or
an impedance analyzer. Table 1-2 shows possible adapter combinations.
The test fixture 16197A can also be connected with any measuring instrument
with 4-terminal pair configuration if an appropriate adapter is used.
For the procedure for attaching an adapter, see the Operation Manual for the
adapter.
Below is the general procedure for attaching an adapter to the test fixture. (For
details, see the Operation Manual for each adapter.
Step 1. Rotate the 7mm connector on the adapter counterclockwise as
viewed from above to completely retract the connecting sleeve.
Step 2. Gently place the test fixture onto the adapter, aligning the mounting
holes with the mounting posts on the adapter, and the 7mm
connector with that on the adapter.
Table 1-2 Adapter for a Measuring Instrument
Measuring
Instrument
Adapter
E4991A Test head (supplied with the E4991A)
E4991B Test head (supplied with the E4991B)
E4982A Test head (supplied with the E4982A), Test Fixture Stand (Opt.
710) and 3.5mm- 7mm Coaxial Adapter (opt.720)
4294A, E4990A-120 42942A terminal adapter
E5061B-3L3/3L4/3L5
with Opt. 005
16201A
Calibration on the 7-mm connector surface may be necessary depending
on the type of measuring instrument. In such a case, perform calibration
on the 7-mm connector surface before connecting the test fixture with the
measuring instrument. For details, see the Operation Manual for the
measuring instrument.