Kenwood TKR-750, Programming Reference Manual

Page: 48 / 83

6 EDIT MENU
43 Field Programming Reference (FPRG) Version: 1.01
It can configure the Decode code with a maximum of 16-
digit DTMF Tone. Enter the code in the edit boxes from
No. 1 to No. 40.
Note: If the same DTMF code is configured in the different table, it
may use the same DTMF code to decode for the Air Remote
function. In this case, the function may not work properly.
(Refer to 6.9 Remote Control Window.)
6.9 Remote Control Window
It can configure the TKR-750/850/751/851 to be
controlled by other transceivers on the “Remote Control”
window. It is possible to control functions assigned to the
PF key or the Auxiliary Port by the Air Remote code.
Air Remote activates the function configured previously
(Channel Up function and Scan On/Off function, etc.)
when the received code is same as the transmitted code
from other transceivers. The code used in this function is
referred to as the “Air Remote code”.
This window consists of PF key and AUX Input/Output
tabs and you can switch the window by clicking the tabs.
"
Conditions od the Air Remote
#
When the Air Remote functions for the Auxiliary
Input (Level) and the PF key are assigned to the
same, the status of the Auxiliary Input (Level) port
gets the preference over the operation of the PF
key. In this case, the Transpond code is not sent
and the Air Remote function is canceled. For
example, when the scan function is assigned to the
Auxiliary Input (Level) port and activating, the PF
keys relating to the Scan operation and the Air
Remote function are not acceptable.
#
It can select a timing to send a Transpond code
from “Before”, “After” or “Both” the received Air
Remote code is processed.
Before:
TKR-750/850/751/851sends the Transpond code
as soon as it receives the Air Remote code. The
Transpond code is not sent when the transmission
is restricted.
After:
TKR-750/850/751/851 sends the Transpond code
after processing the function related received Air
Remote code. The Transpond code is not sent
when the transmission is restricted. Also it is not
sent when that function cannot be processed. This
operation is the same as when the function is
disabled corresponding to the status of TKR-750/
850/751/851 even when the PF key is pressed.
Both:
TKR-750/850/751/851 sends the Transpond code
when receiving the Air Remote code and after
processing the received code. The Transpond
code is not sent when the transmission is
restricted.
#
TKR-750/850/751/851 uses the following channel
to send the code during Scan.
(Refer to 6.6.5
Revert Channel.)
Range
16 digits
0 - 9, A - D, *, #
Default
No. 1 is 159D.
No. 2 - No. 40 are blank.