Kenwood TKR-750, Programming Reference Manual

Page: 31 / 83

Version: 1.01 Field Programming Reference (FPRG) 26
6 EDIT MENU
6.3.7 TX Required in Interval
It can be enable to send a CW ID with the configured
interval.
(Refer to 6.3.2 TX Interval Time.)
Note: “TX Required in Interval” function is not applicable when
sending the CW ID with the “CW ID On” function.
6.3.8 CW ID Override
It can send a CW ID with audio signal when the TX
Interval Time expires during transmission.
(Refer to 6.3.2
TX Interval Time.)
Note:
!
When sending the CW ID configured as CW ID Override On, the
QT/DQT code configured to the channel is encoded regardless
of the Encode with QT/DQT configuration.
(Refer to 6.3.11
Encode with QT/DQT (CW ID).)
!
The CW ID is not sent even when the CW ID On function is
enabled during transmission while CW ID Override is disabled.
6.3.9 Send CW ID to RA
A CW ID tone is sent to the front speaker and the RA
terminal located on the rear panel. It can use to monitor
and confirm by dispatcher.
Note: The CW ID is only sent from the RA line when the channel is
in Simplex mode. In this case, the CW ID is not sent from
the speaker.
6.3.10 CW ID on Channel Change
It can transmit a CW ID when the channel is selected or
changed. The TKR-750/850/751/851 transmits a CW ID
regardless of the configuration of the CW Mod. Delay
Time and the TX Interval Time.
6.3.11 Encode with QT/DQT (CW ID)
It can encode a QT/DQT (Primary) code configured to
each channel while sending a CW ID.
Note: The TKR-750/850/751/851 sends the QT/DQT code
configured to each channel when Encode with QT/DQT is
enabled, and it does not send the QT/DQT code when
Encode with QT/DQT is disabled. However, the new CW ID/
CW Message is sent in conjunction with the Encode with
QT/DQT configuration when the TKR-750/850/751/851
sends another CW ID or CW Message while the CW ID is
independently sent.
(Refer to 6.12 CW Message Window.)
Range
Checked
The CW ID is sent after the
configured interval timer expires only
when TKR-750/850/751/851
transmitted.
Unchecked
The CW ID is sent with the interval
configured in the “TX Interval Time”.
Default Unchecked
Range
Checked
The CW ID is sent with an audio
signal when the TX Interval Time
expires during transmission.
Unchecked
The CW ID is sent after the
transmission ends when the TX
Interval Time expires during
transmission.
Default Unchecked
Range
Checked “Send CW ID to RA” is enable
Unchecked “Send CW ID to RA” is disable
Default Unchecked
Range
Checked
CW ID is sent when the channel is
selected or changed.
Unchecked
CW ID is not sent even when the
channel is selected or changed.
Default Unchecked
Range
Checked
CW ID is transmitted with QT/DQT
(Primary) code of each channel.
Unchecked
CW ID is transmitted without QT/
DQT (Primary) code of each
channel.
Default Unchecked