IEEE-488 Reference
3-42
This command is used to configure the instrument for subsequent measurements on the specified
function. Basically, this command places the instrument in a “one-shot” measurement mode.
The :READ? command can then be used to trigger a measurement and acquire a reading (see
:READ?).
When this command is sent, the Model 2002 will be configured as follows:
• The function specified by this command is selected.
• All controls related to the selected function are defaulted to the *RST values.
• Continuous initiation is disabled (:INITiate:CONTinuous OFF).
• The control sources in all three layers of the Trigger Model are set to Immediate.
• The count values in all three layers of the Trigger Model are set to one (1).
• The delay in all three layers of the Trigger Model are set to zero (0).
• The Model 2002 is placed in the idle state.
• All math calculations are disabled.
• Buffer operation is disabled. A storage operation currently in process will be aborted.
• Autozero controls are set to the *RST default values.
• The acquisition method is set to normal.
• All operations associated with switching cards (scanning) are disabled.
This command is automatically asserted when the :MEASure? command is sent.
PRINT #1, "output 16; :conf:volt:dc"
' Perform :CONFigure operations.
:READ?
This command is typically used to acquire a post-processed reading after the instrument has
been configured by the :CONFigure command. The :CONFigure command places the instru-
ment in a “one-shot” measurement mode. Every time the :READ? command is then sent, a mea-
surement conversion will occur and the reading will be acquired.
When this command is sent, the following commands will be executed in the order that they are
presented:
:ABORt
:INITiate
:FETCh?
When :ABORt is executed, the instrument will go into the idle state if continuous initiation is
disabled. Otherwise, operation will re-start at the beginning of the Trigger Model.
If the instrument is in the idle state, :INITiate will take the instrument out of the idle state. If
continuous initiation is enabled, (:INITiate:CONTinuous ON), then the :INITiate command will
generate an error and ignore the command.
The :FETCh? for details. Note that an “Init ignored” error will not cancel the execution of the
:FETCh? command.
PRINT #1, "output 16; :conf:volt:dc"
' Select “one-shot” DCV function
PRINT #1, "output 16; :read?"
' Perform :READ? operations
PRINT #1, "enter 16"
' Get response message from 2002
Description
Program fragment
Description
Program fragment
Summary of Contents for 2002
