16
You can set up the tuner con
fi
guration for the following types of reception systems:
- DiSEqC™1.0
- DiSEqC™1.1
- Polar antenna (DiSEqC™1.2/ DiSEqC™1.3)
- LNB only or
- OneCable
system
If your reception system is a single-cable system, go to the “OneCable System” option in this section
and continue from there.
Before you start con
fi
guring the tuner you must
fi
rst set both the “Tuner 2 Connection type” and
“Tuner 2 Signal Con
fi
guration” settings.
Tuner 2 Connection type
Select the type of connection for Tuner 2 here. The currently selected setting is shown graphically in the
connection example at the top left of the screen. Either:
Separated:
The second tuner input of the receiver
(LNB2 IN) receives its own signal input
(i.e. there is a direct connection between
the antenna socket and tuner input 2).
See example illustration on the right.
Loop-through:
The current signal received at the Tuner 1
loop-through output is looped through
the second tuner input of the receiver
(LNB2 IN). In this case, the second
tuner can only receive the channel level
currently being received by the
fi
rst tuner.
See example illustration on the right.
See also “Information about antenna
connection and loop-through mode” earlier
in this section.
Connection and set-up
