Kathrein UFS 924, Operating Instructions Manual

Page: 16 / 64

16
You can set up the tuner conf guration for the following types of reception systems:
- DiSEqC™1.0
- DiSEqC™1.1
- Motorized antenna (DiSEqC™1.2/DiSEqC™1.3) USALS
- Simple LNB or
- Single-cable system
If your reception system is a OneCable system, go to the “OneCable System” option in this section
and continue from there.
Before you start con f guring the tuner you must f rst set both the “T uner 2 Connection type” and “T uner 2
Signal Conf guration” settings.
Tuner 2 Connection type
Select the connection type for Tuner 2 here. The currently selected setting is shown graphically in the
connection example at the top left of the screen. Either:
Separated:
The second tuner input of the receiver
(LNB2 IN) receives its own signal input
(i.e. there is a direct connection between
the antenna socket and tuner input 2). See
example illustration on the right.
Loopthrough:
The current signal received at the Tuner 1
loop-through output is looped through
to the second tuner input of the receiver
(LNB2 IN). In this case, the second
tuner can only receive the channel level
currently being received by the f rst tuner.
See example illustration on the right.
See also “Information about antenna
connection and loop-through mode”
earlier in this section.
Connection and setup