Kathrein UFS 924, Operating Instructions Manual

Page: 21 / 64

21
Connection and setup
- Universal
- Simple or
- User-def ned
If you do not use a Universal LNB, press the

button. You can now de f ne the settings for your
LNB type (simple or user-def ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the

button to save the
new values.
Uncommitted Switch
Set the “Uncommitted Switches” here to match the
conf guration of your reception system. You can
select “Off” or a value from “1” to “16” in single unit
increments.
SatPos
Select the f eld “Position”. Set the “SatPos” here to match the con
f guration of your reception system.
You can select “Off” or a value from “1” to “4” in single unit increments.
DiSEqC™ Repeat:
The setting for how often the DiSEqC™ command must be repeated depends on the con
f guration of
your reception system. Refer to the documentation for your reception system or seek assistance from a
specialist engineer.
- Off DiSEqC™ command is not repeated
- 1
DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice
- 3 DiSEqC™ command is repeated three times
Test-Transponder:
Select the “Test-Transponder” f eld. Here you can select a transponder for checking whether your settings
are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the

button.
If you wish to set up more than one satellite (64 max.) for Tuner 1, def ne the settings as just described for
the f rst satellite, for the second satellite and for any further satellites.
When you have completed all settings for Tuner 1, press the

(green) button.
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.
Refer to the documentation for
your reception system or seek
assistance from a specialist
engineer.