17
Tuner 2 signal confi guration (with connection type “Separated” only)
Select the signal conf guration for Tuner 2 here. The currently selected setting is shown graphically in the
connection example at the top of the screen. Either:
Same with Tuner 1:
Both tuners are connected to the same
signal source. See example illustration on
the right.
Different from Tuner 1:
The two tuners are connected to dif ferent
signal sources (separate cables from the
LNB). See example illustration on the right.
The following conf guration options are available for:
Tuner 2 connection type “Separated”/Tuner 2 signal confi guration “Same with Tuner 1”:
All settings are made on Tuner 1. The settings for the second tuner are automatically taken from the f rst
tuner.
Tuner 2 connection type “Loopthrough”:
All settings are made on Tuner 1. The second tuner is fed from the f rst tuner.
Tuner 2 connection type “Separated”/Tuner 2 signal confi guration “Different from Tuner 1”:
All settings must be made separately for the two tuners.
Use the
buttons to set the parameters “T uner 2 Connection type” and “T uner 2 Signal Conf guration”
appropriate to the setting for your reception system.
Now continue as described for the type of reception you selected in the fi rst installation.
Connection and setup
Summary of Contents for UFS 924
