Kathrein UFS 924, Operating Instructions Manual

Page: 19 / 64

19
- Universal
- Simple or
- User-def ned
If you do not use a Universal LNB, press the

button. You can now make the settings for your
LNB type (simple or user-def ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the

button to save the
new values.
DiSEqC™ Repeat:
The setting for how often the DiSEqC™ command must be repeated depends on the con f guration of your
reception system.
- Off DiSEqC™ command is not repeated
- 1
DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice
- 3 DiSEqC™ command is repeated three times
Test-Transponder:
Select the “Test-Transponder” f eld. Here you can select a transponder for checking whether your settings
are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the

button.
If you have selected more than one satellite (four max.) for Tuner 1, you can now de f ne the settings as
described above for the f rst satellite, for the second satellite and then for the third and fourth satellites,
if selected.
When you have completed all settings for Tuner 1, press the

(green) button.
If necessary, the receiver will automatically skip to the settings for the second tuner (assuming that for
the second tuner you selected the type of connection “Separated” and set the signal con f guration
to “Different from Tuner 1”). If this is the case, you should now de f ne the settings for the second tuner
in the same way as you did for the f rst tuner.
Once you have completed the settings for both tuners and the satellites assigned to them, the receiver
will automatically display the screen for the channel search. Continue the f rst installation with the
“Channel Search” section.
Connection and setup
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.
Refer to the documentation for
your reception system or seek
assistance from a specialist
engineer.