KAMAZ 5490, Operation Manual

Page: 82 / 327

4-59
With automatic mode engaged the motion mode,
corresponding to rotary switch position, is displayed.
At manual control engagement the number of the
gear engaged is displayed.
Change of automatic and manual gearbox modes is
possible in any time including the time of vehicle motion.
After engine start an automatic mode of gear box control
is always engaged.
II - To choose the motion mode turn the rotary
switch to necessary position:
DM – forward maneuvering;
D – forward motion (in automatic or manual
mode);
N – Neutral position of the gearbox;
R - reverse gear;
RM – reverse maneuvering
III – For upshifting press on the handle upwards.
IV- For downshifting press on the handle down-
wards.
Automatic gear box control
Start of the vehicle motion
1. Start the engine. Automatic engine mode is en-
gaged. The system automatically chooses the gear for start-
ing from standstill.
2. Shift the rotary switch from «N» position to «D»
position (see Fig. Gear shifter ).
3. Depress the fuel feed pedal and release the park-
ing brake. With fuel feed pedal depressed the clutch is au-
tomatically engaged, and the vehicle starts moving.
For starting from standstill from neutral position
of the gearbox the 1st-4th gear engagement is possible.
All upshifts and downshifts are carried out auto-
matically depending on the vehicle load.
When moving in automatic mode the other gear
can be chosen by pressing on the gear shifter handle up-
wards (III) or downwards (IV). Automatic mode in such a
case is not disengaged.
Upshifting can be carried out by changing of fuel
feed pedal position:
- light pedal depression causes the earlier upshifting;
- strong pedal depression causes the later upshifting.
To drive-up depress the fuel feed pedal. When the
maximum, for these conditions, engine crankshaft speed
in the gear engaged is achieved, electronic control system
automatically upshifts the next gear.