KAMAZ 5490, Operation Manual

Page: 81 / 327

4-58
Gear shifter
Gear box control is carried out by the gear shifter,
located on the steering column, on the right hand (see Fig.
Gear shifter ).
Attention!
Use the rotary switch only on a stationary vehicle
and with engine idle speed.
Simultaneous usage of rotary switch and fuel feed
pedal is prohibited.
Before leaving the vehicle engage the neutral in
the gear box.
If with the driver's door open the rotary switch
is not set in neutral position «N», with this an intermit-
tent audible signal sounds.
I – To choose an automatic or manual gear box
control shift the rotary switch towards the steering col-
umn against stop.
Warning messages
Display Description
Self checking of the system (after ignition
key rota
tion to «ОN» position)
Insufficient pressure in circuit IV of pneu-
matic system. Gear shifting is impossible
Clutch position can not be identified. Vehicle
driving is prohibited till fault correction
Clutch overload. Choose the low gear
Clutch wear limit
Connection of the display and electronics is
broken. Gear boxes System error
Take the foot away from the fuel feed pedal.
If error is still ON, so the system error has
occurred. Further movement is impossible
Emergency temperature of oil in the gear
box
Gear shifter
1 – shifter lever;
2 – rotary switch;
I – choice of control;
II – choice of motion mode;
III – upshifting in manual mode;
IV - downshifting in manual mode
III
IV
II
I
1
2