KAESER ESD 352 SFC, Technical Documentation Manual

Page: 328 / 413

2. Press «Enter» to switch into setting mode.
Setpoint pressure flashes.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.2.3 Load control
Menu
Local mode pB
Active line, current operating mode
·········
Remote mode : loc.-load RC
Key remote : ☐
·········
current pB
3. Use «UP» to select the pB operating mode.
4. Press «Enter» to accept the setting.
5. Adjust the system setpoint pressure pB if necessary (see section 7.4).
Result The local operating mode pB is set.
7.9.6.4 Activating the «Remote control» key
Precondition Access level 2 is activated.
The
< Configuration ➙ Pressure control ➙ Load control > menu is selected.
1. Press «UP» or «DOWN» repeatedly until
Key remote is displayed as the active line.
2. Press «Enter» to switch into setting mode.
The check box for
Key remote flashes.
8 9 p s i 0 8 : 1 5 1 7 6 ° F
5.2.3 Load control
Menu
·········
Remote mode : loc.-load RC
Key remote : ☑
Active line
·········
current pB
3. Use the «UP» key to activate the check box.
4. Press «Enter» to accept the setting.
The «Remote control» key is activated and can be used.
5. Press the «Remote control» key to enable remote mode.
Result The master control is fully configured.
7.9.6.5 Setting the LOAD remote contact operating mode and assigning the input
Precondition Access level 2 is activated.
The
< Configuration ➙ Pressure control ➙ Load control > menu is selected.
7 Initial Start-up
7.9 Configuring the machine for master control
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
109