Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 71 / 100

Figure 34: Configuring SNMP
3.
Select the version of SNMP to be used, either v2c or v3 .
4.
Provide authentication information:
• If you selected SNMP v2c, enter a username.
•
If you selected SNMP v3, enter a username and password.
The password must be at least 8 characters long.
The NSM appliances implement a single username and password, which is effective
only for SNMP communication and is not related to any other username and
password used on the NSM appliance.
5.
To limit SNMP Get requests to specific servers, select Only , and then enter the IP
addresses of the permitted servers.
6.
Click Save .
SNMP System Information
To configure SNMP system information:
1.
Select System Administration > SNMP Monitoring .
2.
Select the System Info tab, which is shown in Figure 35 on page 51.
Figure 35: Configuring SNMP System Information
3.
Enter the following information, with is required for any SNMP-managed device:
• Contact—Contact information for the appliance.
•
Location—Location of the appliance.
51 Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring NSM from the Web Interface