Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 27 / 100

Table 6: Ethernet Port LEDs (continued)
LED2 LED 1 LAN Status
Off Green 100 Mbps connection
Off Orange 1000 Mbps connection
Blinking Orange, Green, or Off Data is being transferred
Off Off No connection
Installing the NSM3000 Hardware
Follow these steps to unpack the NSM3000 appliance and connect it to your network.
To install NSM3000:
1.
Place the shipping container on a flat surface and remove the hardware components
with care.
2.
Remove the NSM appliance from the shipping container and place it on a flat surface.
3.
Mount the NSM appliance in your server rack using the attached mounting brackets.
4.
Plug the power cord into the AC receptacle on the rear panel.
Figure 2: Rear Panel of NSM3000
g040042
Power
supply AC Power
supply
receptacle
AC Power Blank power
supply tray
switch
Fan 0 Fan 1
If your NSM appliance contains two power supplies, plug a power cord into each AC
receptacle.
5.
Plug the other end of the power cord into a wall socket.
If your NSM appliance contains two power supplies, plug each power cord into a
separate power circuit to ensure that the NSM appliance continues to receive power
if one of the power circuits fails.
6.
Plug the Ethernet cable into the port marked ETH0 on the front panel.
7 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Getting Started