Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 36 / 100

Configuring a Regional Server
For details on using the general setup menu items, see “Navigating the Menus” on page 13.
To configure the regional server, select one of the following options by number:
• Typical Settings—Enter 1 to select typical settings. This option provides a simplified
menu to install a regional server. When using these options neither HA nor statistical
report server (SRS) can be in use.
•
Custom Settings—Enter 2 to select custom settings. This option provides full access
to all configuration options including HA and SRS for regional server.
The following sections provide details of these options:
• Configuring Typical Settings on page 16
• Configuring Custom Settings on page 17
Configuring Typical Settings
This section describes the options that are available for a typical installation for the
regional server:
NSM Configuration Main Menu
1> Management IP [10.150.43.205]
The IP address on this server that will be
used for management
2> NSM 'super' password []
Password for 'super' user
3> GUI server one-time password []
Password to initiate authentication
between HA peers and to Central Manager.
This password must be the same for all
NSM servers in this installation.
4> NSM License type []
Specify a license file, or select "Base Install"
to use the built-in limited device license.
A> Apply settings
C> Cancel all changes and quit
R> Redraw menu
Choice [1-4,A,C,R]:
You have the following options:
•
Management IP—Enter 1 to select interface eth0 or eth1 as the primary IP address for
your management server. Once configured, the setup program displays the IP address
for the interface you selected.
•
NSM ‘super’ password—Enter 2 to specify an NSM super password. This password
must be at least eight characters long and is case-sensitive. This password is used by
Copyright © 2010, Juniper Networks, Inc. 16
NSMXpress and NSM3000 User Guide