Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 70 / 100

Figure 33: Edit RADIUS Server Dialog Box
3.
Edit the parameters you want to change and click Save .
Monitoring with SNMP
You can configure your NSM appliance for SNMP monitoring from a network operations
server. The server can then issue periodic SNMP Get instructions to return the status of
the NSM appliance.
You configure SNMP on the NSM appliances with access credentials for either SNMP
v2c or SNMP v3. NSM appliances support read-only access to the System Descriptor
(sysDescr) and Host Resource MIB.
This section provides instructions for configuring NSMappliances for SNMP monitoring.
You must provide access credentials for the SNMP server, a list of IP addresses from
which logon requests will be accepted, and the trap conditions to be reported to the
SNMP server.
To configure SNMP monitoring of your NSM appliance, select System Administration >
SNMP Monitoring . The SNMP window appears. This window contains the tabs described
in the following sections:
• SNMP Configuration on page 50
•
SNMP System Information on page 51
•
SNMP Trap Configuration on page 52
SNMP Configuration
To configure SNMP:
1.
Select System Administration > SNMP Monitoring .
2.
Select the SNMP Config tab, which is shown in Figure 34 on page 51.
Copyright © 2010, Juniper Networks, Inc. 50
NSMXpress and NSM3000 User Guide