Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 28 / 100

Figure 3: Front Panel of NSM3000
CONSOLE ETH3 ETH2 ETH1 ETH0
g040041
Power
LED Hardware
LED
Hard disk LED
Console
port
Ethernet
ports
USB
port
Hard disk
Activity LED
Hard disk
Failure LED
7.
Plug the null modem serial cable into the console port.
This cable was shipped with your NSM3000. If you do not have this cable, use any
other null modem serial cable.
8.
Push the power button in the upper left corner of the front panel.
The green LED below the power button turns on. The NSM3000 hard disk LED turns
on whenever the appliance reads data from or writes data to an NSM3000 hard disk.
The internal port uses two LEDs to indicate the LAN connection status, which is described
in Table 6 on page 6.
Table 6 on page 6 provides LED information for the Ethernet ports.
Initial Setup Configuration
When you first turn on an unconfigured NSM appliance, you need to enter basic network
and machine information through the serial console to make your appliance accessible
to the network. After entering these settings, you can continue configuring the appliance
using the CLI or the Web interface. You are not prompted for the initial setup information
again.
This section describes the required serial console setup and the tasks you need to perform
when connecting to your NSM appliance for the first time:
• Boot the NSM Appliance on page 8
•
Set Up Your Appliance on page 9
Boot the NSM Appliance
To configure the NSM appliance for the first time, you must attach your NSM appliance
to a console terminal running an emulation utility such as HyperTerminal.
1.
Configure a console terminal or terminal emulation utility to use the following serial
connection parameters:
• 9600 bits per second
•
8-bit no parity (8N1)
Copyright © 2010, Juniper Networks, Inc. 8
NSMXpress and NSM3000 User Guide