Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Manual

Page: 33 / 100

CHAPTER 2
Installing and Configuring NSM from the
CLI
This chapter describes how to install and configure NSM on your NSM appliance from
the command-line interface (CLI). It contains the following sections:
• Navigating the Menus on page 13
• Configuring the NSM Software on page 15
•
Configuring a Regional Server on page 16
•
Configuring the Central Manager on page 21
• Configuring Standard Configuration Options on page 25
• The NSM Appliance Default Restoration on page 29
Navigating the Menus
As you configure NSM on your NSM appliance, the following standard navigational menu
options are available to you. This section provides information on general options you
can use during setup and configuration. These options include:
•
General Options on page 13
•
Using nsm_setup on page 14
General Options
The NSM Configuration Main Menu has the following options:
NSM Configuration Main Menu
1> Management IP [10.150.43.205]
The IP address on this server that will be
used for management
2> NSM 'super' password []
Password for 'super' user
3> GUI server one-time password []
Password to initiate authentication
between HA peers and to Central Manager.
This password must be the same for all
NSM servers in this installation.
13 Copyright © 2010, Juniper Networks, Inc.