Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Installation Manual

Page: 209 / 244

3.
Edit the same line by replacing “in.tftpd -s /tftpboot” at the end of the line with “in.tftpd
-s /usr/netscreen/DevSvr/var/cache” . The line should now appear as follows:
tftp dgram udp wait root /usr/sbin/in.tftpd
in.tftpd -s /usr/netscreen/DevSvr/var/cache
4.
Restart the inetd service. You can do so by running the following commands:
/etc/init.d/inetsvc stop
/etc/init.d/inetsvc start
Modifying Timeout Values on the Device Server
On occasion, it may become necessary to modify certain timeout values on the Device
Server, for example if you receive errors when sending bulk command line interface (CLI)
commands or updating certain security systems. You can modify these timeout values
by editing a configuration file on the Device Server called devCommProp.cfg.
To modify timeout values on the Device Server:
1.
Stop the Device Server and any HA Server:
•
If the HA Serer is configured to stop all NSM server processes when it stops, enter
this command:
/usr/netscreen/HaSvr/bin/haSvr.sh stop
•
If the HA Server is not configured to stop all NSM server processes when it stops,
enter these commands:
/usr/netscreen/HaSvr/bin/haSvr.sh stop
/usr/netscreen/DevSvr/bin/devSvr.sh stop
2.
Open the following file in a text editor:
/var/netscreen/DevSvr/be/cfg/devCommProp.cfg
3.
Locate the following line:
:bulk-cli-final-status-timeout (40)
4.
Change the “40” to a value from 1 to 39.
5.
Locate the following line:
:pooh-timeout
6.
Change the “10” to a value 20 (minutes).
7.
Save the file.
8.
Start the HA Server process:
/usr/netscreen/HaSvr/bin/haSvr.sh start
9.
If HA Server process is not configured to start the GUI Server and the Device Server
when it starts, star the GUI Server, and then start the Device Server:
/usr/netscreen/GuiSvr/bin/guiSvr.sh start
187 Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Maintaining NSM