Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Installation Manual

Page: 43 / 244

CHAPTER 3
Installing NSM in a Standalone
Configuration
After you decide how you want to deploy Network and Security Manager (NSM) in your
network and you have identified and procured the appropriate hardware, you are ready
to begin the installation process.
This chapter describes how to install the NSM management system for most typical
cases: GUI Server and Device Server on the same server. These procedures include
performing any prerequisite steps, running the management system installer, running
the User Interface installer on your Windows or Linux client, and validating that you have
installed the management system successfully.
NOTE: The NSM appliance uses a simplified installation procedure. See the
NSMXpress and NSM3000 User Guide for details.
This chapter contains the following sections:
•
Suggested Standalone Configuration Installation Order on page 21
•
Defining System Parameters on page 22
• Prerequisite Steps on page 24
• Installing NSM 2010.4 on page 29
•
Installing the User Interface on page 40
•
Next Steps on page 47
Suggested Standalone Configuration Installation Order
The following procedure summarizes the process for installing NSM for most typical
cases:
1.
Define system parameters that you need to provide during the installation process.
2.
Perform prerequisite steps.
3.
Download the management system and user interface installer software from the
NSM installation CD, or from the Juniper Networks website. Alternatively, you can
21 Copyright © 2010, Juniper Networks, Inc.