Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Installation Manual, Page: 164 / 244

Please press enter to continue:
Ensure the required ports for NSM are available before continuing.
•
The system has sufficient disk space and RAM.
The installer stops any running servers.
NOTE: The management system installer indicates the results of its
specific tasks and checks:
•
“Done” indicates that the installer successfully performed a task.
• “OK” indicates that the installer performed a check and verified that the
condition was satisfied.
• “FAILED” indicates that the installer performed a task or check, but it
was not successful. See the install log for information about the failure.
This log is usually stored in
/usr/netscreen/DevSvr/var/errorLog
. If the
failure happens in the early stages of the install, the log might be in
/tmp
.
The installer performs some preinstallation checks:
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking if ScreenOS 4.0.x or earlier device in network.....ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if installed Device Server is newer................ok
Checking if installed GUI Server is newer...................ok
Checking if installed HA Server is newer....................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
The installer extracts the software payloads and prompts you to install NSM with the
base license.
########## EXTRACTING PAYLOADS ##########
Extracting payload..........................................ok
Decompressing payload.......................................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
Checking device count.......................................ok
Copyright © 2010, Juniper Networks, Inc. 142
Network and Security Manager Installation Guide